Before using the product
Perform the following tasks after receiving the conduit option.
Inspect the conduit option for damage.
If the conduit option appears damaged upon receipt, contact the shipper immediately.
Check the label of model whether it is as same as the model number printed on the package of the conduit
option.
3. Installation Procedure
Conduit Option Assembly and Installation Procedure
DANGER! Electrical Shock Hazard : Do not connect or disconnect wiring while the power is on. Failure to comply
will result in death or serious injury.
Wiring and periodic inspections should be performed at least 10 minutes after disconnecting the input power
And after checking the DC link voltage is discharged with a meter (below DC 30V)
5
To Next Page
Loading...
