How to fix RS-485 communication error in LSIS Inverter?
To resolve an RS-485 communication error, ensure the converter has electric power. Verify that the master is polling the inverter. Check the wiring for Ground Fault (GF) and correct it according to section '11.3 Installation'. Set the correct value in accordance with '11.3 Installation'. Revise the User Program (Note1). Also, consult the converter manual for further guidance.
Critical safety and environmental considerations for installing the inverter correctly.
Diagram and description of control signal terminal connections for inverter operation.
Guidance on connecting essential external devices like power supply and motor.
Detailed procedure for modifying parameter values using the inverter's keypad interface.
Instructions for setting operating frequency and performing basic start/stop operations.
Explanation of various methods for setting the inverter's operating frequency.
Guide to setting operating commands via keypad, terminals, or communication.
How to configure acceleration, deceleration times, and S-curve patterns.
Explanation of different Volts/Hertz (V/F) patterns for motor speed control.
Real-time monitoring of key inverter operating parameters via the keypad display.
Procedures for viewing current faults and accessing fault history for troubleshooting.
Setting up motor thermal protection to prevent overheating and damage.
Configuration of overload detection levels and trip actions to protect the motor.
Setting up functions to prevent motor stalling during acceleration, constant run, or deceleration.
How the inverter detects and responds to output phase loss conditions.
Step-by-step guide for connecting the RS485 communication interface for remote control.
Overview of the inverter's built-in protective functions and fault displays.
Troubleshooting guide with causes and solutions for common inverter faults.
Safety warnings and guidelines for performing maintenance on the inverter.
To Next Page
General