Channel Calibration
MXD70 Conductivity Setup and
Operating Guide
- 27 -
Channel Calibration
Calibration Reminder
By enabling the calibration reminder the user can
configure a calibration interval, which when expired
will activate an alarm and channel message on the
front screen.
At the end of a sensor solution calibration, if
calibration reminder is enabled, the user will be
prompted to update the cal due date by the
calibration interval and so clearing an alarm if active.
/ – Select Option
EXIT
– Cancel
– Save Selection
Calibration Interval
Sets the interval time for the calibration alarm.
The Next Cal Date will update to show the date of the
next calibration alarm.
/ – Increase / Decrease Digit
– Select Next Digit
EXIT
– Cancel
– Save Value
Next Calibration Date
Sets the exact date of the next calibration alarm.
The Calibration Interval will update to show the
number of days to the next calibration date.
/ – Increase / Decrease Digit or Text
– Select Next Item
EXIT
– Cancel
– Save Entry
To Next Page
Loading...
