LUCCI 210012 - Trouble Shooting

Installation Instructions
6 | Page
TROUBLE SHOOTING:
Warning: For your safety, ensure the power is switched OFF before starting the troubleshooting procedures
TROUBLE PROBABLE CAUSES SUGGESTED REMEDY
1
．
No functions operate.
Warning: Some tasks
can
only to be performed by a
qualified technician.
Main power not restored.
Replace fuse. Turn ON circuit breaker. Turn
ON wall switch.
Wall switch power to the fan
remote is OFF.
Switch wall switch ON, to power the
remote.
Receiver wiring incorrect.
Verify wiring connections according to
label and wiring diagram.
Transmitter and receiver DIP
switches do not match.
Set transmitter and receiver to same DIP
switch setting.
The remote is too far from the
receiver.
Move closer to receiver.
2. Remote LED/LCD no
display.
Battery too weak.
Replace with all new batteries. Do not mix
the old and new batteries.
Batteries at wrong polarity. Reinstall the batteries at right polarity.
The contacts in battery
compartment are corroded or bent.
Clean corroded contacts.
Bend contacts back to their correct
position.
Poor contact with batteries.
Roll the batteries to get them to sit in the
compartment, or replace with other brand
batteries.
3. Operates only at close
range.
Signal blocked from reaching
receiver.
Extend antenna in canopy, or move it for
better reception.
Batteries too weak.
Replace with all new batteries. Do not mix
the old and new batteries.
4. More than one fan
operates interference at
same area.
RF interference.
Change DIP switch settings to a different
code. Each pair of transmitter and receiver
must have unique DIP switch code.