Whitehaven Fan Installation Instructions
9 | P a g e
FINISHING THE INSTALLATION
• Ensure the earth wiring is secure and correct, by performing an earthing continuity test from the fan’s
accessible metal body back to the earth terminal at the terminal block on the mounting bracket.
• Loosen the two screws at the bottom of the mounting bracket by half a thread. (Fig. 11)
• Slide the canopy up to the mounting bracket and align the key holes on the canopy with the screws on the
mounting bracket. Turn the canopy until it locks into place with the narrow section of the key holes and
secure it by tightening the two screws. Avoid damaging the electrical wiring prepared previously. (Fig. 11)
• Attach the canopy cover onto the canopy by pushing the lugs into the holes. (Fig. 11)
USING YOUR CEILING FAN
REMOTE CONTROL (Fig.12)
1. Open the battery compartment cover by removing the securing screw and insert 2 x AAA battery. Note the
correct battery polarity (+/-) when inserting the battery, and then replace the cover and secure with the screw.
2. Test the remote by pressing and hold any button. A blue LED will be lit up at the top of the remote to indicate
that there is power to the remote and it is ready for use to control the fan.
3. Follow the guide below to operate the fan and learn the functions.
The LED globe has a 3-step dimmable function which is controlled by an ON/OFF switch.
When the LED light is ON and at 100% brightness, press the light button “ON and then OFF within 3 seconds”,
to dim the LED light. Repeat pressing ON and then OFF within 3 seconds to dim further in the following
sequence: 100% brightness → 50% brightness → 15% brightness → 100% brightness.
The remote has memory function. If the fan or light is turned off by the isolating switch over 7 seconds, the
next time to turn on the fan or light will be on last setting
To Next Page
Loading...
