17
Abbreviated Dialing (AD)
(continued)
3. If you are using a telephone with a display, press the Menu button
and then press the softkey below Prog.
If your telephone does
not
have a display or if Prog is not available
on your display, press the button (if administered)
OR, Dial the AD Program access code __________. [dial tone]
4. Dial the Personal List number (1, 2, or 3).
5. Dial the list item (1, 2, 3...) .
6. Dial the number you want to store (up to 24 digits).
Note: You may also be able to use the softkeys to add AD special
functions such as Pause, Mark, Suppress, or Wait into the
programmed telephone numbers.
If you are programming an outside number, be sure to include
a trunk code, if applicable.
7. Press . [confirmation tone]
Number is stored.
8. Repeat Steps 5 through 7 if you want to program additional items on
the same list; hang up and begin again at Step 1 if you want to
program items on another list.
9. Hang up to end programming.
Note: Record your personal list items on the Abbreviated Dialing list on
the cards in the tray under the telephone; group, system, and
enhanced list can be obtained from your system manager.
To place a call using an AD list button or code
1. Press the or or buttons (if administered)
OR, Dial the appropriate AD List code:
List 1 __________
List 2 __________
[dial tone]
List 3 __________.
Note: An (Enhanced List) may also be available; see
your system manager.
2. Dial the desired list item (1, 2, 3...).
Call is automatically dialed.
Program
#
Grp List Sys List
Enhcd List
To Next Page
Loading...
Need help?
General
