24
continued on next page
Self-Administration
(continued)
To administer any of the above features on available buttons on your
telephone
1. Press the Menu button and then the softkey below Admin.
Note: The telephone must be idle; that is, there must NOT be any
active or held calls.
2. If necessary, enter your security code at the telephone dial pad.
When you have entered the security code, press the softkey below
Done.
The display shows the first SELECT FEATURE screen which lists
the first set of four self-administrable features. To see the second set
of four features, press the Next button. To go back one menu screen,
press the Prev button.
3. Press the softkey below the feature you want to place on an available
feature button such as CPkUp (Call Pickup) or SAC (Send All Calls).
Note: If you choose the Automatic Dialing or Group Paging feature,
the display prompts you to add a number such as a telephone
number, extension, or trunk code that will be associated with
this particular button. When you see the correct number on
the screen, press the softkey below Done.
Note: If you wish to see the full name of any of the features on the
feature menu screens (called LongMode), press the softkey
below Expl?. The display, such as the one below, provides
the full name of the feature and allows you to select that
feature for an available button. (Press the softkey below Selct
and go on to Step 4.):
You can administer this feature from this (LongMode) screen with the
feature’s full name OR you can return to the (ShortMode) screens,
shown in Figure 5, which have the feature’s abbreviation rather than
its full name.
4. Press the button on which you wish to assign this feature.
If the feature is successfully administered on the feature button, the
display shows: “Button Programmed!” Go on to Step 5.
CALL PICKUP
ShortMode? Next Selct
To Next Page
Loading...
