Lucent Technologies DACS II - Page 52

2-36
DACS II/Rel 8.2.6 April 2000
DACS II/Rel 8.2.6
MML
RTRV,STATE,EQPT,NPC,LPBK
53131
00
NPC not specified in input range command
--
NPC not equipped, or non-ANSI type
opq
Loopback Type
Values of "opq" are presented in NPC order, grouped within
messages by DS2s. Since there are 7 DS2s within a Hybrid
DS3, seven rows are generated in the output message, one for
each DS2. Each DS2 may either carry four DS1 circuits or three
E1 circuits. If a DS2 carries E1 circuits, then the fourth position
in each row will not show any data. It will show dashes instead.
o Explanation
D
This is an NPC that carries a DS1 circuit.
E
This is an NPC that carries an E1 circuit.
-
This is the fourth position of a DS2 carrying E1s.
-
This NPC is not equipped or provisioned.
-
This NPC is not in input range.
pq Explanation
FA
Line loopback towards facility active with AIS
insertion
FN
Line loopback towards facility active without AIS
insertion
RA
Remote (far-end) line loopback is active with AIS
insertion
NN
No loopback active
00
NPC not specified in input range command
--
NPC not equipped or provisioned.