Need help?Do you have a question about the Lufft WS600-UMB and is the answer not in the manual?
General| Brand | Lufft |
|---|---|
| Model | WS600-UMB |
| Category | Weather Station |
| Language | English |
Provides essential safety guidelines for installation and operation.
Defines the intended purpose and operating conditions for the equipment.
Details potential consequences of improper installation or usage.
Details the procedure for mounting the sensor onto a mast.
Explains how to align the sensor correctly to North for accurate wind direction.
Guides on choosing an optimal location for sensor installation.
Details the connection procedure for the ISOCON-UMB module.
Instructions on using surge protection devices.
Lists the default configuration settings of the device.
Explains how to use the UMB-Config-Tool for setup.
Describes the sensor selection process within the configuration tool.
General overview of configuration adjustments.
Configuration of general device parameters like ID and protocol.
Settings for temperature, humidity, and fan operation.
Configuration of pressure, wind, and compass parameters.
Configuration options for the rain gauge functionality.
Settings for optimizing power consumption.
Procedure for resetting accumulated precipitation data.
How to perform functional tests using the configuration tool.
Selecting channels for data polling during testing.
Demonstrates a typical measurement polling scenario.
Explains different modes for sensor heating to prevent icing.
Details the automatic heating mode for optimal sensor performance.
Describes disabling the heating function.
Explains Mode 1 heating with temperature threshold control.
Describes an energy-saving heating mode with specific conditions.
Details the measurement ranges and accuracy for each sensor.
Contact information and resources for technical assistance.
Details the data communication protocol in binary format.
Describes how devices are addressed using Class ID and Device ID.
Details data communication using the ASCII protocol.
Describes how to request measurement data using ASCII.
Describes how to communicate using terminal mode.
Details communication using the SDI-12 protocol.
Lists prerequisites for operating in SDI-12 mode.
Lists the command set available for SDI-12 communication.
Details on communicating via the Modbus protocol for PLC integration.
To Next Page
