Page
9
of
35
3 INSTALLATIONS
3.1 Brief introduction
Ceiling Mounted dehumidifier can be installed in many places, depending on the requirements of
owners. It can also integrate with current ventilation system via duct system. This chapter records
info about preparation work, and installation work and etc. Please serve it as a guide before
installation.
3.2 Delivery and storage
To ensure the quality and reliability of each dehumidifier, it has been thoroughly tested in factory.
If dehumidifier has to be stored for a while prior to installation, please take notes of the following:
①Keeping transport package in good condition;
②Avoiding physical damage;
③Dehumidifier should be stored indoor and covered properly to prevent dust, frost and rain
intrusion.
3.3 Inspection before installation
Unpack package and check machine: If any damage is found, please contact supplier /
manufacturer.
3.4 Moving machine
Please check the dehumidifier weight before any loading / unloading. The dehumidifier is equipped
with caster wheels, it can move on the ground. For moving the unit of a longer distance, it is advice
to use proper equipment (trolley or forklift) to move the goods. It should be take note that the
dehumidifier shall be lifted up properly and the lifting point should be away from the motor, control
system and exposed pipe to avoid any damages onto the equipment.
3.5 Installation Location
For best operation and maintenance service, it is advice to install the dehumidifier indoor / inside of
room with extra space for routine maintenance/checking in order to prevent condensation inside
the dehumidifier, the unit should not be exposed to environment where temperature is below the
process air’s dew point. Please place the device near to power source.
NOTE: Please provide enough space around the dehumidifier for troubleshooting and
maintenance service purpose.
To Next Page
Loading...
