What to do if detection failed in the computer VC-AC09 Lumens DVR?
If the Lumens DVR VC-AC09 is not detected by the computer, go to the [Console], activate the [Device Manager], disable the USB3.0 device, and then restart the system.
General| Video Compression | H.264 |
|---|---|
| Motion Detection | Yes |
| Operating System | Embedded Linux |
| Power Supply | DC 12V |
| Remote Viewing | Yes |
| Network Interface | RJ45 (10/100 Mbps) |
| USB Interface | USB 2.0 |
Guidance on using the product safely in the recommended operating environment.
Instructions for proper storage to prevent damage or hazards to the device.
Procedures for safely cleaning the device using appropriate methods.
Specifies the lowest acceptable hardware specifications for the system.
Outlines the suggested hardware specifications for optimal device performance.
Lists the operating systems compatible with the device.
Identifies and describes the physical parts of the capture box.
Illustrates and explains how to connect the device to other equipment.
Guides on accessing and using the video filter properties in common software.
Explains how to view and manage the filter output pin in common software.
To Next Page