What to do if there is no image output from Lumens Camcorder VC-BC701P?
If your Lumens Camcorder VC-BC701P isn't showing an image, check the power and PoE supply. Ensure the output signals are set to streaming. If connected to a monitor, verify that the monitor supports 4K output. Also, try replacing the cables to rule out any faults.
Why is my Lumens Camcorder VC-BC701P image severely delayed?
If the VC-BC701P image from your Lumens Camcorder is severely delayed, use 4K, 1080p, or 720p at 60/50 Hz signals instead of 25/30 Hz signals.
What to do if RS-232 cannot be controlled on Lumens Camcorder?
If RS-232 control isn't working on your Lumens Camcorder, confirm that the connection is correct (RS-232 Input / Output). Also, ensure that the Baud rate setting matches that of the control equipment.
General| Camera Type | PTZ Camera |
|---|---|
| Sensor Type | CMOS |
| Optical Zoom | 30x |
| Digital Zoom | 12x |
| Audio Input | 3.5mm Line In |
| Pan Angle | ±170° |
| Preset Positions | 256 |
| Control Interface | RS-232, RS-422, IP |
| Video Resolution | 1920x1080 |
| Frame Rate | 60fps |
| Image Sensor | 1/2.8 inch CMOS |
| Resolution | 1080p |
| Aperture | F1.6 (Wide) ~ F4.7 (Tele) |
| Viewing Angle | 2.3° (tele) - 65° (wide) |
| Shutter Speed | 1/1 ~ 1/10, 000 sec |
| Video Output | HDMI, 3G-SDI |
| Tilt Angle | -30° to +90° |
| Pan Speed | 0.1 - 300°/sec |
| IP Interface | RJ-45 |
| Protocols | VISCA, Pelco-D |
| Power | DC 12V / PoE+ |
| Output Interface | HDMI, 3G-SDI |
| Dimensions | 180 x 180 x 186 mm |
| Tilt Speed | 0.1° ~ 100° / sec |
To Next Page
