Lumex Splash - Preparing The Tub For Installation

NOTE:
 • Donotchargeinthebathroomoranyhumidarea.Alwayschargeinadryarea,ensuringyour
handsaredryrst.
 •Donotcoverthebatteryorchargerwhilecharging.
 •Alwayschargeonahardsurface.
 •Duringcharging,thetemperatureofthechargerboxmayexceed40
o
C/104
o
F but will gradually
decreaseoncetheconstantgreenlightontheboxappears.Userswithsensitive/damagedskin
shouldtakecareandallowapproximately3hoursfromstartofchargingbeforehandlingthebox.
 •Ensurethatnometalobjectstouchthecontactsonthebattery,asthiswilldamagethebattery.
 •UseonlytheLumex®Splashchargersuppliedtochargethebatteryandfornootherpurpose.
3. Preparing the tub for installation
i) Removeanynon-slipmatsfromthetub.
ii) Ensurethebottomofthetubiscleanandsmooth,withnooilortubcleanerresiduesthatwill
preventthesuctionfeetfromsticking.
iii) Thesuctionfeetmaynotbesuitableintubsthathavebeenre-enamelledorthathaverippledor
texturedsurfaces.
iv) Itisessentialthatthesideaps(see g 1) do not catch under any obstructions such as integral
tub handles, handrails, soap dishes and faucets when rising. If your tub has integral handles
andthesideapsarelikelytocatch,optionalsideapprotectorsareavailable(seesection15,
“Accessories”).Thesehookoverintegraltubhandles (see g 3) and help guide the side aps
smoothlyoverthehandles.
v) Ensuretherearenooverheadobstructionsattherearofthetub,wherethebathliftwillbe
positioned(e.g.wall-mountedshelves/cupboardsorshowerxtures),astheymayinterferewith
theupwardmovementoftheseat.Wherepossible,removesuchobstructions.Alternatively,
thebathliftmustbeplacedfurtherforwardinthetubtoavoidtheobstruction(seesection4,
“Installingthebathlift”).
6