Need help?Do you have a question about the Lust CDA34.010 and is the answer not in the manual?
General| Control Method | V/F control, Sensorless vector control |
|---|---|
| Storage Temperature | -20°C to +60°C |
| Enclosure Rating | IP20 |
| Overload Capacity | 150% for 60s |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit |
| Communication Interface | Modbus |
| Humidity | 5% to 95% (non-condensing) |
| Altitude | Up to 1000m |
| Input Voltage | 3-phase 380-480V (-15% ~ +10%) |
| Operating Temperature | -10°C to +40°C |
| Cooling Method | Forced air cooling |
Specifies the power range of the CDA3000 inverter drive system.
Essential safety precautions and guidelines for safe handling and operation of the inverter drives.
Specifies the intended applications and compliance with EC Machinery Directive and EN standards.
Outlines the company's and user's responsibilities regarding safe installation and operation.
Instructions for correctly connecting the grounding lead for EMC and safety compliance.
Guidelines for wiring the motor phases, PTC sensor, and associated shielding.
Procedure for connecting the inverter module to the mains power supply, including filters and circuit breakers.
Instructions for wiring and configuring control signals and terminals.
Guidance on selecting the appropriate commissioning mode based on application and terminal assignment.
Table of flash codes, KEYPAD display abbreviations, and their causes/remedies.
To Next Page
