6)Display will show the Dissolved Oxygen values ( mg/L )
at the same time the bottom display will show the Temp.
value of the measured solution.
7)Rinsed the probe accurately with normal tap water after
each series of measurement.
Oxygen in the air
During the DO measurement, press the " Function Button "
( 3-6, Fig. 1 ) once, the display unit will show " %O2 "
instead of " mg/L " , it show the air Oxygen value for
reference.
Press the " Function Button " once again, the Display
unit will return to " mg/L ".
Change the Temp. unit to ℉
If intend to change the Temp. unit from to ,℃℉
please refer to chapter 8-7, page 25.
"% Salt" compensation value adjustment
If intend to change the % Salt compensation value,
refer chapter 9-8, page 26.
"Height" compensation value adjustment
If intend to change the Height compensation value,
refer to chapter 8-9, 8-10, page 26 page 27.
9
To Next Page
Loading...
Need help?
General
