3)After make the measurement, please rinse the electrode
in distilled water.
* After the measurement, the " pH electrode "
( 3-5, Fig. 1 ) should insert into the "
Protection bottle " ( 3-7, Fig. 1 ).
* PE-12, PH-07A, PH-04A is the consumer accessory.
5-2 Data Hold
* During the measurement, press the " Hold Button "
( 3-3, Fig. 1 ) momentarily to hold the measured
value. The LCD will show a " HOLD " symbol.
* Press the" Hold Button " once again to release the
data hold function.
5-3 Data Record ( Max., Min. reading )
1)The data record function records the maximum and
minimum readings. Press the " REC Button " ( 3-4, Fig.
1 ) momentarily to start the Data Record function,
shows " REC " on the display.
2)With the " REC " symbol on the display.
a)Press the " REC Button " ( 3-4, Fig. 1 ) momentarily,
the " REC MAX " symbol along with the maximum
value will appear on the display.
b)Press the " REC Button " ( 3-4, Fig. 1 ) momentarily
again, the " REC MIN " symbol along with the
minimum value will appear on the display.
When display shows " REC MAX " or " REC MIN ",
* press the " Hold Button " ( 3-3, Fig. 1 )
momentarily will delete the max. ( min. ) value,
the display will show the " REC. " only and
execute the memory function continuously.
c)To exit the memory record function, press the "
REC " button for 2 seconds at least. The display will
revert to the current reading, not show " REC "
11
To Next Page
Loading...
