Lutron Electronics PH-222 - Call Data

6-2 Call data
1)Turn on the meter.
Press the " Hold Button " ( 3-3, Fig. 1 ) momentarily,
LCD shows " HOLD ".
Following, press the " REC Button " ( 3-4, Fig. 1 )
continuously until display shows following , then
release the button.
Example :
28
The total data point that
ttL are saved into the memory.
2)Uses " Button " ( 3-2, Fig. 1 ) or " Button " ▲▼
( 3-4, Fig. 1 ) to call the data that already saved into
the memory.
Note :
* During call the data, the " pH " unit will be flashed.
Example :
8.07
pH flashing
25.0 ℃
* Press " Hold Button " ( 3-3. Fig. 1 ) will exit the
data call function.
13