6. CONDUCTIVITY/TDS MEASURING
and CALIBRATION PROCEDURE
The meter default function are following :
*The display unit is set to conductivity ( uS, mS ).
*The temperature unit is set to .℃
*Temp. compensation factor is set to 2.0% per C.
*Auto range.
*Auto power off.
*The sampling time of data logger function is
2 seconds.
Fig. 3
If the meter along with the conductivity
probe are used for a certain period,
then it should execute the calibration
procedures, refer chapter 6-3, page 21.
19
To Next Page
Loading...
