Luvox F100 - 4 LCD Monitor Setup ··············································Page.11; Driver Installation Page.12; Touch Alignment (Calibration) Page.13

- 12 -
Driver installation
Each LUVOX device can be equipped with an ELO touch screen.
The 4 ELO touch technologies adapted in LUVOX devices are:
• ACCUTOUCH (5-wire resistive)
• CARROLLTOUCH (Infrared)
• INTELLITOUCH (Surface acoustic wave)
• SURFACE CAPACITVE (only produced on project basis)
Visit the ELOTOUCH corporate website for more information about
each available technology.
www.elotouch.com/Technologies/default.asp
Each LUVOX LCD monitor powered with an ELO touch screen
comes with an ELO driver CD-ROM in the accessory box. You will
need to install this driver CD-ROM before the monitor becomes
fully functional. Please insert the CD-ROM and follow the
instructions on the screen. After you have installed the driver, you
will be automatically asked to calibrate your monitor. Afterwards,
your monitor is ready to use.
If the driver CD-ROM is lost, damaged or out of date (Cfr use with
WINDOWS VISTA), you can download the latest driver version
from the ELOTOUCH website. Select the correct driver based on
your operating system and touch technology.
www.elotouch.com/Support/Downloads/dnld.asp
- 13 -
Touch Alignment (Calibration)
The touch response must be aligned to the video image (this is
called calibration). Normally this is done when the touch drivers
are initially installed. But in some conditions re-calibration may be
needed, for example after swapping or replacing monitors on the
same machine.
On regular Windows systems the Alignment/Calibration utility is
run from the Control Panel. This calibration procedure is also valid
on a LUVOX All-In-One system.
• Click the Start button.
• Select Settings, then Control Panel (on later operating
systems the Settings step is omitted)
• Open the Elo applet by double-clicking the Elo icon.
• On Windows XP it may be necessary to click the Show Classic
View button to see the Elo icon.
• The Alignment/Calibration button is always on the General tab
of the Elo Control Panel tab set
• Click the button, touch target in the upper left corner.
• The target will reappear in the lower right corner
• Touch the upper right target.
• The next screen is an alignment check. Touch various
positions and check the cursor movement.
• Clicking the redo arrow icon will display the targets again to
rerun the alignment routine.
• You must click the Accept button to store the new alignment
points.
NOTE: You may find other interesting features in the ELO control
panel regarding sounds, right mouse click emulation, etc…