LUX KONOzw - Power Off and System Verification; Remove Old Thermostat Base

4 | 856.234.8803
This manual is a comprehensive guide for the installaon and wiring
of your KONOzw thermostat.
Step 1.1: Turn o the power at the circuit breaker to both
your heang and cooling systems before performing any
wiring.
Step 1.2: Conrm that your heang
and cooling system is powered down by changing the
temperature on your exisng thermostat. The heang
and cooling should not come on but may show the
temperature change on your exisng thermostat.
Note: Your system should not make any noise and you
should not feel any air exing your vents.
Step 1.3: Remove the front of your old thermostat
from its base.
If you see thick black wires, wire nuts, or any
labels that say 120-240VAC or High Voltage, your
system is not compable with KONOzw. Please call
LUX Technical Support at 856.234.8803 before proceeding with your
installaon. If you do not see any high voltage labels or wires, you may
connue with the installaon process.
HIGH
VOLTAGE
STOP