LUX KONOzw - Prepare Wall and Mount Base; Install Trim Plate or Anchors

LuxProducts.com | 7
Step 2.2: Verify that each wire has been properly labeled and remove
each wire from its terminal — make sure that they don’t fall into the
wall.
Step 2.3: Remove the mounng screws from the base of the old
thermostat and remove the base from the wall.
Step 2.4: Separate KONOzw from its base.
Step 2.5: If you would like to use the trim
plate or wall anchors, you may install them
now.
Step 2.6: Pull the wires from your wall
through the center hole of the KONOzw
base. Secure the base to the wall using the
included mounng hardware. Follow the
built in level to ensure that it is straight.
INSTALLATION
2. WIRING
Step 2.4
Step 2.5
Step 2.6