LVI Touch E3 - Page 19

P16MI417 - A02 - 01/16 19
|
FOR THE INSTALLER AND FOR
ADVANCED USERS
OTHER FUNCTIONS FOR THE INSTALLER
01. Press “Main menu” button
A
02. Press the “Parameter setting” button
I
(long press)
03. Create house (See “Create house” section, p 7)
04. Radio pairing (See “pairing radiators” section, p 7)
05. To delete a device
• Press “Delete a device”button
• Press “heating”button
• Use the arrows to scroll through the list of paired devices.
• Select the device to be deleted
  -Note:Tomakesurethattherightdeviceisdeleted,identifyitrst(Seebelow)
  -Note:Iftherstdeviceinaroomisdeleted,alldevicesinthatroom
will be deleted.
 •Press“Greencheck”buttontoconrm
06. To delete all devices
• Press “Delete all devices”button
 •Press“Greencheck”buttontoconrm
• Press “Red cross”to decline
07. Identify a device and edit some device information; such as name, power,
surface temperature limitations and sequential mode.
• Press “Identify a device”button
• Press the “Radio button”
• Make the device send a radio message
- (On Yali, press OK and wait for the backlight to go off)
• Make a note of the ID-number that is displayed on 3rd line of the screen >>
• To be sure it is right, send a second radio message from the device and compare
the ID-number (it could happen that another device coincidently sends
a message at the same time, therefor it is good to repeat this operation).
FOR THE INSTALLER AND FOR
ADVANCED USERS
UK