LVI Touch E3 - Heating Settings; Update Firmware

|
20 P16MI417 - A02 - 01/16
• If you want to edit device information/settings, press the button with a Red dot
(long Press):
- Device name,
- Power,
- Set front panel max surface temperature level.
> Press “Heating rate maximum level” rate.
   >SelectP1,P2orP3.NOTE:therstpairedradiatormusthavethesame 
or higher value than the rest of the radiators in the room, otherwise the energy
calculation will be wrong.
   >Press“Greencheck”buttontoconrm.
- For double radiator, change to sequential control.
> Press “Sequential control”button
> Select “No”(default setting) if the radiator’s front and back panel should be
evenly heated.
> Select “Yes”if the radiator’s front and back panel should be heated sequentially.
   >Press“Greencheck”buttontoconrm.
08. Screen lock
• Press “Screen lock” button
• Enter your personalized code (it must contain 4 characters)
 •Press“Greencheck”buttontoconrm
Note: the default code is 1066
09. Heating settings
Set Minimum and Maximum allowed temperatures in each room.
• Press “Heating Settings” button
• Press a room button
10. WiFi settings (See “WiFi settings” section, p 21)
11. General factory default (all updates and user data will be erased except WiFi-
settings. They are reset under WiFi settings (See “WiFi settings” section, p 21)
by pressing the the Red “Reset” button (long press)
 •Press“Greencheck”buttontoconrm
• Press “Red cross”to decline
12. Update firmware
 •InsertSDcardwithnewrmware
 •Press“Updatermware”
 •Press“Greencheck”buttontoconrm
• Press “Red cross”to decline
Please wait until the end of the update procedure before removing the microSD from the Central
Unit.Theendoftheprocedureisdenotedbytheappearanceofthewi-buttonontheCentralUnit
FOR THE INSTALLER AND FOR
ADVANCED USERS
UK