Troubleshooting
Problem Cause Solution
representative if problem repeats, for battery pack
replacement options.
LED is flashing RED at
any station.
The battery pack voltage has not
reached 6.0V within 30 minutes and
the charger has timed out.
Contact your LXE representative for battery pack
replacement options.
Solid YELLOW /
AMBER LED when
battery pack is inserted
in the charger.
The battery pack is too hot or too cold
to charge.
Remove battery pack from the charger and allow it to adjust
to room temperature.
Note: If the battery pack is left in the charger, it will
cool down or warm to a temperature upon which the
charger will begin the charge cycle. However,
depending on the temperature of the battery, it may
take 2-3 hours to adjust. The cool-down / warm-up of a
battery pack is much quicker if the battery is not in the
battery well.
E-EQ-MX7TCHGROG-A [ 11 ] MX7 Tecton™ Battery Charger User Guide
To Next Page
Loading...
