Introduction
The LXE MX7 TectonBattery Multi-charger is designed to simultaneously charge four Rechargeable Lithium Ion (Li-Ion)
Battery Packs. The time required for charging is dependent upon the battery pack temperature and conditions.
This user’s guide is intended to familiarize the user with the safety and operating instructions necessary to use the MX7 Tecton
Battery Multi-charger (LXE Model MX7390CHARGER, MX7391CHARGER) to charge LXE Rechargeable Lithium Ion Battery
Packs (MX7A380BATT, MX7A381BATT). This guide should be readily available to all users and maintenance personnel using
this charger.
The charger should be located in an area where it:
l Is well ventilated.
l Is not in high traffic areas.
l Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
l Has enough clearance to allow easy access to the power port on the back of the device.
l Is protected from rain, dust, direct sunlight or inclement weather.
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell batteries sealed inside the mobile device.
Quick Start
The following Quick Start instructions are abbreviated and intended to give a brief overview of the process to be followed.
1. Assemble the power supply.
2. Connect the power supply to the charger.
3. Insert a battery into a charging bay.
4. When the battery is charging, the setup process is complete.
Note: Store the charger and batteries when not in use in a cool, dry, protected place.
E-EQ-MX7TCHGROG-A [ 1 ] MX7 Tecton™ Battery Charger User Guide
To Next Page
Loading...
