TEXTRON LYCOMING OPERATOR'S MANUAL
SECTION
4
0-360 and
ASSOCIATED
MODELS
1. DAILY PRE-FLIGHT.
a. Engine
(1) Be sure all switches
are in the "Off"
position.
(2) Be
sure magneto ground
wires are connected.
(3) Check
oil
level.
(4)
See that fuel
tanks are
full.
(5)
Check fuel and oil line connections;
note minor indications
for
repair at
50 hour inspection. Repair any
leaks before aircraft is flown.
(6) Open
the fuel drain to remove any
accumulation of water and
sediment.
(7) Make sure all shields and
cowling are in place and
secure. If any
are missing or damaged,
repair or replacement
should be made
before the aircraft is flown.
(8) Check
controls for general condition,
travel, and freedom
of
operation.
(9) Induction system
air filter should be inspected
and serviced in
accordance with the
airframe manufacturer's
recommendations.
b. Turbocharger
(1) Inspect
mounting
and connections
of turbocharger
for security,
lubricant
or air
leakage.
(2) Check engine crankcase breather for restrictions to breather.
2. 25-HOUR
INSPECTION
(ENGINE).
After the
first twenty-five
hours
operation time; new, remanufactured or newly overhauled engines should
undergo
a 50 hour inspection
including
draining and
renewing lubricating
oil. If engine has
no full-flow oil filter, change oil
every 25 hours. Also, in-
spect
and clean suction and
pressure screens.
4-2
To Next Page
Loading...