Lycomin 0-360 - High Oil Temperature; Rough Engine

TEXTRON
LYCOMING OPERATOR'S
MANUAL
SECTION 6 0-360 and
ASSOCIATED
MODELS
TROUBLE
PROBABLE CAUSE REMEDY
Failure of Engine
to Develop Full
Power (Cont.)
Improper
fuel
Drain and refill tank
with recommended fuel.
Faulty ignition Tighten
all
connections.
Check system with
tester. Check
ignition
timing.
Replace or repair mount.
Rough Engine Cracked
engine
mount
Defective mount-
ing
bushings
Uneven
compression
Insufficient oil
Low Oil
Pressure
Air lock or dirt
in relief valve
Leak in suction
line or pres-
sure line
High oil
temperature
Defective pres-
sure gage
Stoppage
in oil
pump intake pas-
sage
Insufficient air
cooling
Install
new
mounting
bushings
Check compression.
Fill to proper level with
recommended oil.
Remove and clean oil
pressure relief valve.
Check
gasket
between
accessory
housing
and
crankcase.
See
"High Oil
Temp-
erature" in "Trouble"
column.
Replace
Check
line for
obstruction.
Clean suction strainer.
Check air inlet and out-
let for deformation or
obstruction.
High Oil
Temperature
6-4