M-tech LEGEND II PLUS - S;RF Meter; Channel Select; Adjusting RF Gain; Emergency Channel Select

4.4 S/RF meter
S/RF meter indicates the receiving signal strength in RX mode, and it is
used as RF power indicator in TX mode. S/RF meter indicators have 4
steps from 1 (weak) to 4 (strong).
4.5 Channel select
➥ Push or push and hold
[UP]
/
[DN]
keys on the microphone or turn the
channel switch knob either clockwise or counterclockwise.
4.6 Adjusting RF gain
Turn the RF gain knob counterclockwise
to reduce the reception of strong signals.
Reduce the reception
of strong signals
4.7 Emergency channel select
➥ Push and hold the
[CH9/19]
key in the microphone to activate
instantly these emergency channels.
NOTE:
The channel selector unable to select the channel once emergency
channel selected.
4.8 Hi-Cut select
Switch Hi-Cut mode select switch to ON to reduce high frequency
noise when reception is noisy due to long distance.
SECTION 4
BASIC OPERATION
13