M3 Mobile UL10 - 3.1 Bluetooth; 3.1.1 Bluetooth configuration; 3.1.2 Getting connected

Using this manual
25
3. Application usage
3.1 Bluetooth
3.1.1 Bluetooth configuration
Turning on
Click on Bluetooth icon on task bar (
) and choose ‘Enable Bluetooth’ to turn on the
Bluetooth module.Once the Bluetooth is on, the task bar icon will change to
to indicate it
is enabled.
To turn it off, simply disable the Bluetooth after click on
icon from task bar.
M3 UL10 can use two different Bluetooth stacks:
1. StoneStreetOne (default)
2. Microsoft
Bluetooth stack can be changed from
Start

Settings

System

BT Select
The device must go through power cycle after stack change.
3.1.2 Getting connected
Set Bluetooth Connection
Bluetooth connections can be configured using BTExplorer. To launch BTExplorer, click on