16
Now that the green light
is ashing your Hoverbike
Drone is ready to y. Hold
the arming button until the
button lights up solid red
and the motors sing out
another tune, the motors
should then remain quiet.
Hold the yaw (left stick of your transmitter) fully to the
right and down until you hear a long tone from the Pix-
hawk buzzer and the Pixhawk light goes solid green.
YOUR HOVERBIKE DRONE IS NOW ARMED AND READY TO FLY.
Slowly raise the throttle. Once above half throttle your Hoverbike Drone will take to
ight. This may happen rapidly so keep a safe distance.
Once your Hoverbike Drone has ascended to around a meter or two slowly reduce the
throttle so that the Hoverbike Drone hovers.
You can control your Hoverbike Drone with the right hand transmitter stick, twist it
around by moving the left stick left or right (yaw) and move it up or down by moving
the left stick up and down (height).
To land, slowly lower the throttle stick until your drone is safely back on the ground.
FLIGHT
This procedure is the same for every ight:
Please refer to ‘How controls work on page 13.
Do not move the Hoverbike Drone from this position;
it should be left until the light on the Pixhawk ashes
green. This time is required for GPS satellites to be ac-
quired and for the home position to be logged, and the
ashing green indicates that the correct number of sat-
ellites are acquired. The Hoverbike Drone will return to
this position if commanded by you or by radio failure to
return to launch (RTL), so make sure it is not positioned
close to any thing that it may land on or y into.
Pixhawk:
Arming button:
Motors:
Pixhawk:
Pixhawk:
Contents
System overview 4
In the box 5
Caring for Drone 6
You + Drone 7
Safety rst 8
First time setup 9
Batteries 12
Controls 12
Warning signals 14
First ight 15
Every ight 17
Flying modes 19
About Drone 20
To Next Page
Loading...