MA DRONE 3 - BEFORE EVERY FLIGHT; Pre-flight checks

17
BEFORE EVERY FLIGHT
Below are the required steps for every ight. See unfolding/folding in-
structions on page 6.
Ensure that batteries are fully charged and strapped in.
Ensure that the locking pins used for folding the Hover-
bike Drone are secured.
Connect the batteries.
Start up
Contents
System overview 4
In the box 5
Caring for Drone 6
You + Drone 7
Safety rst 8
First time setup 9
Batteries 12
Controls 12
Warning signals 14
First ight 15
Every ight 17
Flying modes 19
About Drone 20
Note: Loiter mode is heavily dependent on the accelerometers being well calibrat-
ed. To check the calibration of your Hoverbike Drone’s accelerometers connect it to
Mission Planner and check the articial horizon in the Flight D ata tab. The articial
horizon should match the red lines and the red arrows should point to zero ±1˚ when
your Hoverbike Drone is on a at and level surface.
Although we will have calibrated your accelerometers before shipping please check
this before your rst ight. If it is not completely level please re calibrate your acceler-
ometers using the Initial Setup - Accelerometer Calibration tab in Mission Planner.
CORRECT WRONG