21
Wiring
The stock wiring system takes power from two 6S battery packs in parallel and passes
this through a power module. This power module does two things. The rst is to mon-
itor the voltage and current to tell the Pixhawk ight controller what the current state
of the batteries is. The second thing is to convert a little of the voltage to 5V to power
the ight controller. After the power passes through the power module it continues on
to the motor speed controllers to drive the motors.
Spares
You can purchase the following spares from our website:
Contents
System overview 4
In the box 5
Caring for Drone 6
You + Drone 7
Safety rst 8
First time setup 9
Batteries 12
Controls 12
Warning signals 14
First ight 15
Every ight 17
Flying modes 19
About Drone 20
Motors Motor speed controllers Propellers
Ducting Landing gear
(skids and folding legs)
Flight controller
GPS Macro micro Carry bag
To Next Page
Loading...