MAAX xstream User Manual

18
18
Swim Spa
Temperature
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature will show
on the display unless the primary pump has
not been running, in which case two dashes
(--) will show on the display. If two dashes are
displayed, you must  rst start the pump by
pressing the JETS 1 pad. Wait until the water
temperature is displayed (approximately 2
minutes).
The set temperature of your Swim Spa may
easily be increased or decreased at any time
using the UP or DOWN pads. When either of
these pads is touched, the set temperature
will be displayed in the LCD display window.
Each successive touch will change the set
temperature 1°F (0.5°C) in the chosen direction.
After 3 seconds the LCD will automatically
display the water temperature or dash lines.
If the Swim Spa is set in Standard mode or in a
 ltration cycle, adjusting the set temperature
may result in activating the heater. When
the heater is operating, the heat icon will be
displayed in the LCD.
JETS 1
Touch the JETS 1 pad to activate the primary
 ltration and jet pump. The sequence of the
jet action is: 1 touch = Low jets
2 touches = High jets
3 touches = O
JETS 2
Touch the JETS 2 pad to activate the number 2
Jet pump. The sequence of jet action is:
1 touch = Low jets
2 touches = High jets
3 touches = O
The low speed operation of Pump 1 and 2
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various Swim Spa functions (i.e., turn on Swim
Spa light, set temperature, etc.). The following
table de nes the pads:
Pad Use
UP
• Increase temperature
• Change time settings
• Used in alternate programming
sequences
Down
• Decrease temperature
• Change time settings
• Used in alternate programming
sequences
Time
• Exit programming
• View time of day
• Change set times of Swim Spa
 lter cycles
•Lock/unlock temperatures
• Lock/unlock temperatures
Prog
• Switch modes
• Set time and  ltration cycles
Light
• Turn all spa light on or o
Jets 1
• Activate primary  ltration pump
•Used in alternate programming
sequences
Jets 2
• Activate therapy pump

MAAX xstream Specifications

General

Brand	MAAX
Model	xstream
Category	Hot Tub
Language	English