Operation
MHTP24EB by MacAllister
GB
IE
In more detail...
17
Cutting
> Adjust the handle so that it ts the intended cut and start the
product as described.
> Cut and remove branches exceeding the cutting capacity of this
product using a proper pruner before operation.
> Move the cutting device
lightly through the cutting
surface in a sweeping
motion following the shape
of the hedge or shrub. A
slight tilt downwards of the
cutting device in the direction
of motion is recommended
for optimum cutting
performance.
> Do not to rush and do not
attempt to cut too much with one stroke of the cutting device.
> First cut both sides from the bottom cutting upwards to the top.
This will prevent any of the cuttings falling into the path of the
area still to be cut (Fig. 13).
> After cutting the sides proceed to the top (Fig. 14).
NOTE: Tr y to keep the cutting device angled at
approximately 15° to the cutting surface.
5-10°
Fig. 15
Fig. 14 Fig. 15
Fig. 13
To Next Page
Loading...