Mac allister MHTP24EB - Quick start

GB
IE
Getting started...
Quick start
MHTP24EB by MacAllister
08
Set up
Cold start
Warm start
Adjust
Mix petrol and 2-stroke engine oil
inacontainerthoroughly,andll
the mixture into the tank
Close choke Prime until
fuel is visible
Pull recoil starter
handle, make a blasting sound
Set ignition
switch to “I”
Open choke
Set ignition
switch to “I”
Open choke
Set switch to
position “I”
Move choke
lever to the
“closed“ position
Press primer
7-10 times until
fuel is visible
Pull recoil starter handle
slowlyuntilyoufeeladenite
resistance and then give it a
brisk,strongpull.Repeatuntil
the engine starts *
When the engine
starts,movethe
choke lever to the
“open“ position
Operate
Allow the engine
to warm up for at
least 30 seconds
Set switch to
position “I”
*Iftheenginecannotstartafter8timesofpulling,ortheenginestallsquickly,movethe
choke lever to the “open“ position and then repeat this step until the engine starts .
Ensure choke
lever is in the
“open“ position
Pull recoil starter handle
slowlyuntilyoufeeladenite
resistance and then give it a
brisk,strongpull.Repeatuntil
the engine starts
Operate