Mac allister MHTP24EB - Trouble shooting

GB
IE
In more detail...
Trouble shooting
MHTP24EB by MacAllister
26
Trouble shooting
Suspectedmalfunctionsareoftenduetocausesthattheusercanx
themselves. Therefore check the product using this section. In most
cases the problem can be solved quickly.
WARNING! Only perform the steps described within
theseinstructions!Allfurtherinspection,maintenanceand
repair work must be performed by an authorised service
centreorasimilarlyqualiedspecialistifyoucannotsolve
the problem yourself!
Problem Possible cause Fault correction
1. Engine does not start 1.1 Not enough fuel in fuel
tank
1.2 Primer has been not
pressed at cold start
1.3 Primer has been
pressed at warm start
1.4 Spark plug is wet
1.5 Spark plug is damaged
1.6 Spark plug connector
lose
1.7 Ignition switch is not
switched on
1.8 Choke lever position is
wrong
1.1 Add fuel
1.2 Press the primer and
restart
1.3 Dry spark plug
1.4 Dry spark plug
1.5 Replace spark plug
1.6 Attach properly
1.7 Set ignition switch to “I”
1.8 Set the choke lever
position correctly as
the starting steps
2. Engine stops 2.1 Not enough fuel in the
tank
2.2 Cutting device is
blocked
2.3 Cold machine does not
warmup
2.1 Add fuel
2.2 Remove blockage
2.3 Let the engine warm
up at idle for a while
3. Unsatisfactory cutting
performance
3.1 Cutting blade is dull/
damaged
3.2 Cutting material
exceeds capacity
3.1 Have a specialist to
sharpen or replace it
3.2 Only cut materials
according to the
capacity of the product
4. Excessive vibration /
noise or exhaust
4.1 Cutting device is dull/
damaged
4.2 Bolts/nuts are loosen
4.3 Petrol/oil is incorrect
4.1 Replace with a new
one
4.2 Tighten bolts/nuts
4.3 Empty unused petrol/
oilandrellwiththe
correct petrol/oil