Mac allister MHTP24EB - Care and maintenance

Care and maintenance
MHTP24EB by MacAllister
GB
IE
In more detail...
19
Cutting
WARNING!Alwaysswitchtheproductoff,lettheproduct
cool down and disconnect the spark plug connector
beforeperforminginspection,maintenanceandcleaning
work!
> Keep the product clean and free from debris after each use and
before storage.
> Regular and correct cleaning of this product will help ensure safe
use and prolong the life of the product.
> Inspect the product before each use for worn and damaged parts.
Do not operate it if any parts are broken or show signs of wear.
WARNING! Only perform repairs and maintenance work
according to these instructions! All further works must be
performedbyaqualiedspecialist!
General cleaning
> Clean the product with a slightly damp cloth and mild soap. Use
a brush for areas that are hard to reach.
> Pay particular attention to the air vents (19) and to the cutting
device.
> Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Donotusechemical,alkaline,abrasiveorother
aggressive detergents or disinfectants to clean this
product as they might be harmful to its surfaces.
> Check for worn or damaged parts. Replace worn parts as
necessary or contact an authorised service centre before using
the product again.