Mac allister MHTP24EB - Fuel and engine oil

Before you start
MHTP24EB by MacAllister
GB
IE
Getting started...
05
Fuel and engine oil
WARNING! This product is not supplied with fuel-oil
mixture in the engine! Before operating this product it is
essentialtollitwithfuel
Thisproductisequippedwitha2-strokeengine,thefuelandoiltank
arecombinedanditisessentialtollfuel-oilmixturebeforeoperating
thisproduct.Observethetechnicalspecictionsforsuitablefueland
engine oil.
WARNING! Fuel and oil are highly inammable! Fumes
willexplodeif lit!Ensurethat thereareno nakedames
aroundtheproduct!Donotsmokewhilellingfuelandoil!
< Place the product on a stable, level surface. We recommend
layinganon-ammablesheetundertheproduct.
< Mix a regular-grade unleaded petrol and a quality engine oil for
air cooled 2 stroke engines in a suitable container (Fig. 1).
> Use an anti-oxidant added quality oil expressly labelled for air-
cooled 2 stroke engine use (JASO FC GRADE OIL or ISO EGC
GRADE).
> Do not use BIA or TWC mixed oil. (TWC = 2 stroke Water-Cooling
type)
> The recommended mixing ratio for petrol:oil is 40:1.
> Unscrew and remove the fuel tank cap (10).
> Fillcorrectlymixedfuel/oilintothetankusingafuelfunneltted
withaltertoavoiddebrisenteringthetank.Donotoverll.Leave
a minimum 5 mm of space between the top of the fuel and the
inside edge of the tank (11) to allow for expansion (Fig. 2).
NOTE: Never mix fuel and oil directly in the tank of the
product.