EN
25
In
more
detail...
MLM1737
by MacAllister
Starting/Stopping
WARNING!
Before starting, put the product on a at surface free of
high grass! Clean the underside of the deck!
Start the motor carefully according to instructions. Keep your feet well
away from the cutting blade (12c)!
Do not tilt the product when starting the motor.
Starting / stopping
Ensure the extension cord is well hooked on the cord retainer (2a). Connect the
plug to the power supply via the extension cord.
1. Stand behind the grip handle (1).
2. While holding the safety switch button (2) pressed
(Fig. 17, step 1), pull the start levers (3) towards the
grip handle (1) (Fig. 17, step 2).
3. After the mower starts, release the safety switch
button (2).
4. The product starts moving forward and begins
mowing.
5. Release the start levers (3) to stop the mower.
1. Make sure that the lawn is clear of stones, sticks, wire or other objects that
could damage the product or its product.
2. Do not cut wet grass because it tends to stick to the underbody of the
product, preventing the proper discharge of grass clippings, and it could also
cause you to slip and fall.
Mowing
NOTE:
The product can only be started by pressing the safety
switch button (2) followed by squeezing the start levers (3). Reverse
operation cannot start the product.
Operation
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
2a
2
3
1
3
2.
1.
2.
Fig. 17
General operation
To Next Page
Loading...
