MacDon D1X Series User Manual (English)

Other manuals for MacDon D1X Series

Operator's Manual308 pages

Assembly Instructions108 pages

Questions and Answers:

M
Marissa DennisAug 15, 2025
How to fix ragged cutting of crop with MacDon D1X?
- A
  Angie WilsonAug 15, 2025
  To address ragged or uneven cutting of crop with your MacDon Farm Equipment, start by adjusting the knife hold-downs. If the issue persists, replace any worn or broken cutting parts, check the windrower's engine speed, and consider reducing ground speed or increasing reel speed. Adjusting the reel position and finger pitch can also help. Other solutions include lowering the cutting height, steepening the header angle, straightening any bent knives, aligning the guards, and installing stub guards.
F
flowerswilliamAug 18, 2025
What to do if MacDon Farm Equipment does not pick up downed crop?
- K
  Kurt LongAug 18, 2025
  If your MacDon Farm Equipment is not picking up downed crop, try the following: Lower the cutterbar, increase the header angle, lower the reel, move the reel forward, increase the reel speed or reduce ground speed, increase the finger pitch aggressiveness, or install crop lifters.
R
Robert FloydAug 22, 2025
Why is there excessive header vibration in my MacDon Farm Equipment?
- M
  Michael SimonAug 22, 2025
  If you're experiencing excessive header vibration with your MacDon Farm Equipment, start by adjusting the knife hold-downs. If the vibration continues, adjust the knife timing.
R
Richard RayAug 25, 2025
How to prevent heads shattering with MacDon D1X Farm Equipment?
- C
  Carrie CummingsAug 26, 2025
  If the heads are shattering or breaking off while using your MacDon Farm Equipment, try reducing the reel speed, raising the reel, reducing the ground speed, or operating at night when humidity is higher.
M
Michelle LozanoAug 28, 2025
What to do if knife is plugging in MacDon D1X?
- M
  Mrs. Michelle SilvaAug 28, 2025
  If knife plugging occurs with your MacDon Farm Equipment, try lowering the reel or moving it rearward. Alternatively, increase the ground speed.
A
Ashley FisherAug 31, 2025
Why is material accumulating in the knifehead of my MacDon D1X Farm Equipment?
- G
  ghillAug 31, 2025
  If material is accumulating in the gap between the cut-out in the endsheet and the knifehead on your MacDon Farm Equipment, and the crop heads are leaning away from the knifehead hole in the endsheet, add knifehead shields, except in damp or sticky soils.
A
April GarnerSep 4, 2025
How to stop excessive bouncing in MacDon D1X?
- D
  Deborah RoseSep 4, 2025
  If your MacDon Farm Equipment is bouncing excessively at normal field speed, adjust the header float.
R
Robert DuffySep 7, 2025
Why is crop not being cut at ends by MacDon Farm Equipment?
- H
  Heather HammondSep 8, 2025
  If crop is not being cut at the ends by your MacDon Farm Equipment, and the reel is not frowning or not centered in the header, adjust the reel's horizontal position or reel frown.
A
Alexis JacobsonSep 12, 2025
What to do if divider rod runs down standing crop in MacDon Farm Equipment?
- C
  Christopher ThompsonSep 12, 2025
  If the divider rod is running down standing crop when using your MacDon Farm Equipment, and the divider rods are too long, remove the divider rod.