Need help?Do you have a question about the Mackie DLM12 and is the answer not in the manual?
General| Product color | Black |
|---|---|
| Housing material | - |
| Recommended usage | DJ |
| Suitable for outdoor use | Yes |
| Magnet type | Ferrite |
| Speaker type | 2-way |
| Woofer diameter | 305 mm |
| Number of drivers | 1 |
| Speaker placement | Floor, Wall-mountable |
| Audio output channels | 2.0 channels |
| Driver diaphragm material | Paper |
| Woofer diameter (imperial) | 12 \ |
| Subwoofer driver diameter (imperial) | 1.75 \ |
| Amplifier class | D |
| Sensitivity | 128 dB |
| Frequency range | 38 - 20000 Hz |
| RMS rated power | 1000 W |
| Crossover frequency | 1600 Hz |
| Peak Music Power Output (PMPO) | 2000 W |
| Total Harmonic Distortion (THD) | 1 % |
| Voice coil diameter | 44 mm |
| Connectivity technology | Wired |
| AC input voltage | 220 - 240 V |
| Power source type | AC |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 250 W |
| Operating temperature (T-T) | 0 - 40 °C |
| Package depth | 508 mm |
| Package width | 521 mm |
| Package height | 490 mm |
| Package weight | 16800 g |
Weight and Dimensions| Depth | 363 mm |
|---|---|
| Width | 389 mm |
| Height | 403 mm |
| Weight | 14100 g |
Demonstrates a sound system setup for a small club using DLM loudspeakers and a subwoofer.
Shows a typical DJ setup using DLM loudspeakers connected to a mixer and laptop.
Explains how to connect multiple DLM loudspeakers in series using the THRU jack.
Illustrates a complex sound system for a large club using DLM loudspeakers and subwoofers.
Details how to connect the AC power cord to the loudspeaker and the outlet.
Explains the operation of the main power rocker switch for turning the unit on and off.
Details the connector types and signal acceptance for the combo input jacks.
Explains the function of the mic/line switch for adjusting gain on channel 1.
Describes the OLED display's function in showing loudspeaker information and settings.
Explains how to use the channel buttons to adjust level, EQ, and FX send parameters.
Details the 3-band EQ (Low, Mid, High) and its effect on frequencies.
Explains how to access and adjust system processing presets like EQ, Delay, FX, and Feedback.
Explains the Feedback Destroyer settings (Off, On, Clear, Hold).
Reiterates Mackie's role in providing rigging systems and installer responsibility.
Provides common troubleshooting steps for issues like no power, no sound, and noise.
To Next Page
