9
The resistance to wind loads in the closed and locked state depends on the respective construction of the
windows and balcony doors. If wind loads in accordance with DIN EN 12210 (in particular test pressure p3) are
to be expected, suitable hardware are to be selected and agreed on separately in conjunction with the
respective window construction and the frame material.
The dened maximum sash weights for the individual hardware designs must not be exceeded.
The component with the lowest permissible load capacity determines the maximum sash weight. Application
diagrams and component mappings must be observed.
The hardware and the rebate spaces must be suciently ventilated, especially during the construction phase,
so that they are not exposed to direct moisture or condensation.
The hardware are to be kept free of deposits and contamination by building materials (construction dust,
gypsum plaster, cement etc.), therefore windows must be covered accordingly.
The hardware must only be cleaned or polished with mild, pH-neutral detergents in diluted form.
Attach the operating label in a clearly visible manner to the built-in li and slide sash. The operating label is
located in the basic box or in the "corner deection" package.
To Next Page
Loading...