Need help?Do you have a question about the Macrom 42.15 and is the answer not in the manual?
General| Frequency Response | 10 Hz - 30 kHz |
|---|---|
| Crossover Frequency (High-Pass) | 50 Hz - 500 Hz |
| Crossover Frequency (Low-Pass) | 50 Hz - 500 Hz |
| THD @ 4 Ohms | 0.05% |
| Bass Boost | 0dB - 12dB @ 45Hz |
Explains stereo, mono-bridged, and power output configurations.
Allows selection of STEREO, LEFT (MONO), or LEFT+RIGHT modes.
Unit has Soft Start, Overheating, and Output Short Circuit protection.
Sensitivity adjustable from 100mV to 2V for various sources.
Visual indicator for the amplifier's power status.
Connects the audio source signal to the amplifier.
Selects the input signal mode (stereo or mono).
Adjusts the amplifier's input sensitivity.
Terminals for connecting speakers to the amplifier.
Protects the unit from electrical overloads.
Terminal for connecting the power source.
Select a location with good air circulation to prevent overheating.
Steps for placing, marking, drilling, and securing the amplifier.
Connect the ground lead to a secure point on the car's chassis.
Positive and negative terminals for the left speaker output.
Positive and negative terminals for the right speaker output.
Line-level audio inputs for left and right channels.
Fuse holder for circuit protection.
Connection for the main power supply from the battery.
Connects to the chassis ground.
Receives signal to turn the amplifier on/off.
Configure input mode: Stereo, Left (Mono), or L+R.
Adjust amplifier input sensitivity, typically from 0.1V to 2V.
Details stereo and bridged power output for model 42.15.
Details stereo and bridged power output for model 42.17.
Specifies frequency range and signal-to-noise ratio.
Covers input sensitivity, impedance, and speaker load compatibility.
Includes power supply requirements, weight, and dimensions.
To Next Page
