Macrom 44.13 - Page 2

CONNECTIONS / ANSCHLUSSE / CONNEXIONES /
COLLEGAMENTI / CONEXIONES
Fig. 3/Abb. 3
4
1. The unit may be damaged by wrong lead connection, therefore read carefully the
instructions of this manual for the correct connection of the leads.
2. The last lead to be connected is the one to the positive (+) terminal of the battery;
connect this lead only after having completed and checked all other connections.
3. Due to the power of the 44.13 it is imperative that all connections are clean and
secure in order to avoid damage to the unit.
4. Be sure to install the amplifier in a position v/ith good air circulation and good heat
dissipation.
5. In case of fuse replacement make sure to replace it with a fuse of the same amperage.
The use of fuses with the wrong amperage may seriously damage the components
of the unit.
If fuses blow more than once, carefully check all electrical connections. Also have your
car's voltage regulator checked. Do not attempt to repair the unit yourself. If repairs
are ever needed, take the unit to your MACROM dealer or to your nearest MACROM
service station.
6. In order to obtain the best possible performance from this unit, make sure that the
temperature inside your car is within the range of -10 C and +60 C before you switch
the unit on. Good air circulation is essential to prevent heat build-up inside the unit.
7