Need help?Do you have a question about the Macrom M2A.1000 and is the answer not in the manual?
Connects low-level audio sources to the amplifier.
Connects speaker-level audio sources to the amplifier.
Adjusts the input signal sensitivity to match the source.
Includes Low Pass and Sub Sonic filter frequency adjustments.
Increases low-frequency output level.
External Bass Control and its ON/OFF switch.
Pre-amplified signal output and status indicator.
Includes Fuses, 12V, Remote, and GND terminals.
Terminals for connecting speakers (left and right channels).
Selectable cut frequency between 30 to 300 Hz.
Adjusts subsonic filter frequency from 20 to 50Hz.
Increases low frequency range from 0 to +12dB.
Controls amplifier volume via a remote unit.
Details minimum acceptable impedance and connection guidelines.
Shows valid and invalid speaker configurations based on load.
Instructions for connecting positive, negative, and remote terminals.
Connects audio output from car radio to amplifier's low level input.
Connects speaker outputs from car radio to amplifier's high level input.
Adjusts gain according to the audio level output.
To Next Page
General
