setAt 527
• The setaProp command can also set ancestor properties.
Parameters
listProperty
Required. A symbol (Lingo only) or a string that specifies the name of the
property whose value is changing.
newValue Required. The new value for the listProperty property.
Example
These statements create a property list and then adds the item #c:10 to the list:
newList = [#a:1, #b:5]
put newList
-- [#a:1, #b:5]
setaProp newList, #c, 10
put newList
Using the dot operator, you can alter the property value of a property already in a list without
using
setaProp:
newList = [#a:1, #b:5]
put newList
-- [#a:1, #b:5]
newList.b = 99
put newList
-- [#a:1, #b:99]
Note: To use the dot operator to manipulate a property, the property must already exist in the list,
child object, or behavior.
See also
ancestor, property, . (dot operator)
setAt
Usage
setAt list, orderNumber, value
list[orderNumber] = value
Description
Command; replaces the item specified by orderNumber with the value specified by value in the
list specified by list. When orderNumber is greater than the number of items in a property list,
the
setAt command returns a script error. When orderNumber is greater than the number of
items in a linear list, Director expands the list’s blank entries to provide the number of places
specified by
orderNumber.
Example
This handler assigns a name to the list [12, 34, 6, 7, 45], replaces the fourth item in the list with
the value 10, and then displays the result in the Message window:
on enterFrame
set vNumbers = [12, 34, 6, 7, 45]
setAt vnumbers, 4, 10
put vNumbers
end enterFrame
To Next Page