MACROMEDIA DIRECTOR MX 2004-DIRECTOR SCRIPTING - Page 585

voiceSetRate() 585
voiceSetPitch()
Usage
voiceSetPitch(integer)
Description
Command; sets the pitch for the current voice of the text-to-speech engine to the specified value.
The return value is the new pitch value that has been set.
Parameters
integer
Required. An integer that specifies the pitch for the text-to-speech voice. The valid range
of values depends on the operating system platform and text-to-speech software.
Example
This statement sets the pitch for the current voice to 75:
voiceSetPitch(75)
See also
voiceSpeak(), voicePause(), voiceResume(), voiceStop(), voiceGetRate(),
voiceSetRate(), voiceGetPitch(), voiceGetVolume(), voiceSetVolume(),
voiceState(), voiceWordPos()
voiceSetRate()
Usage
voiceSetRate(integer)
Description
Command; sets the playback rate of the text-to-speech engine to the specified integer value. The
command returns the new value that has been set.
Parameters
integer
Required. An integer that specifies the playback rate that the text-to-speech engine uses.
The valid range of values depends on the operating system platform. In general, values between
-10 and 10 are appropriate for most text-to-speech software. If an out-of-range value is specified,
the rate will be set to the nearest valid value.
Example
This statement sets the playback rate of the text-to-speech engine to 7:
voiceSetRate(7)
See also
voiceSpeak(), voicePause(), voiceResume(), voiceStop(), voiceGetRate(),
voiceGetPitch(), voiceSetPitch(), voiceGetVolume(), voiceSetVolume(),
voiceState(), voiceWordPos()