Madison Candy Tech CT-04+ - Charging the CT-04+ Candy Tech Smart Go Time

GB-06
1. Plug the micro USB plug of the charging cable
magnet charge connector
2. Align the ve contact pins of the magnet charge
connector with the contact rail on the underside of
the CT-04+ Candy Tech Smart Go Time as shown
in the picture. The ve male contact pins inside the
USB-peg must t snugly into the female contact
rail of the CT-04+ Candy Tech Smart Go Time.
Your CT-04+ Candy Tech Smart Go Time will not
charge with an improper electrical connection.
Charging the CT-04+ Candy Tech
Smart Go Time
Charge the CT-04+ Candy Tech Smart Go Time for ca. 2 hours before rst
use.
Re-charge the battery before the battery charge drops below 20 %. The
“Battery Low icon” will appear on the screen. A complete charge of the
battery of the device takes about 1.5 hours.
Charge time may depend on the power source used. A standard USB
charger will normally charge with a higher current than a computer USB
port.