SELF-HELP
READING THE ENGINE ERROR CODES
Operating manual T225 / T230 127
Reading the engine error codes
In case of an engine problem, the engine controller displays
error codes in the form of flash sequences. You can read the
error codes with the “Diagnostics on/off” and “Diagnostics
selection” switches.
You do not need the diagnostic function in normal mode, it is
only for reading error codes in case engine problems occur.
Fig. 113: Diagnostics switch
1 “Diagnostics selection” rocker switch
2 “Diagnostics on/off” switch
3 Yellow warning light
4 Red warning light
The switches for diagnostics are located in the switch
cabinet.
Reading error codes
If there is an engine problem, one of the warning lights goes
on. When you read the error codes, the engine has to be
turned off and the ignition key has to be in the I position.
X Turn the ignition key to the 0 position.
3 The engine and the ignition are turned off.
X Turn the ignition key to the I position.
3 The ignition is switched on.
DIAGNOSTIC
MENUE
11-C26-067-064A-8
0
0000000
°F
250
105
175
km/h
MPH
120
80
°C
1
1/2
km
0
10
20
30
40
50
60
40
0
10
20
30
3
4
To Next Page
Loading...
