USING THE DELAY FEATURE
PAUSING THE WASH CYCLE SEQUENCE
The start of the dishwasher can be delayed between 1 and 24 hours, using one hour increments.
To u!lize this feature:
1) Press “ON/OFF” bu"on to “ON” posi!on
2) Press “PROGRAM” bu"on
3) Press “DELAY” bu"on once for each hour of delay
(e.g. press bu"on 3 !mes to delay start by 3 hours)
To cancel the delay feature:
1) Press “ON/OFF” bu"on to “OFF” posi!on.
In order to make any changes to the selected wash cycle sequence, load addi!onal items, or
remove previously loaded items, the dishwasher must be put into “PAUSE” mode. The
dishwasher can be put into “PAUSE” mode at any !me during the wash cycle.
To temporarily pause the washing process:
1) Press and hold the START/RESET bu"on for approximately 3 seconds to cancel
the exis!ng program mode.
2) Make the necessary changes to the wash cycle sequence selec!on or
add/remove items from the dishwasher.
3) Ensure that the door is closed and the latch is fully engaged.
4) Press the START/RESET bu"on once.
5) The dishwasher will immediately resume opera!on using the most recently
selected wash cycle sequence.
NOTE: The dishwasher will automa!cally go into PAUSE mode if the door is opened. The door must
be closed and the latch engaged for the dishwasher to resume opera!on. Always use the above
steps.
-PAGE 18-
To Next Page
Loading...
Need help?
General
